NVT NV-716J-PVD 16 Channel Power-Video-Data Cable Integrator

Typically installed in the wiring closet or IDF room, the NV–716J–PVD is a passive "pass-through" wiring device that efficiently consolidates camera power, video, and pan/tilt/zoom data onto a minimum of 4–pair RJ–45 cables.

Power, video and data are converted at the camera using the NV–218A–PVD transceiver which utilizes a single 4-pair cable with RJ-45 connectors to deliver each camera's signals to the NV–704J–PVD. Up to four cameras are supported. The NV–704J–PVD receives low-voltage camera power from any third-party Class 2 power supply. Control Room connections are achieved with a single 4-pair RJ-45 cable (Exception: Two cables are required when all four cameras are in use and one or more require data.) Control Room connections may be made using the NV–413A, NV–452R, NV–862J, NV–1662J, or NV–3262J. All equipment employs industry-standard EIA/TIA 568B pinouts.

NV-716J-PVD

Specifications *

Video

Impedance

UTP RJ-45 Connectors

100 ohms

Power

16 to 24AWG (0.5mm to 1.3mm)

Power Distance Chart

Power Supply Voltage	24 VAC	28 VAC	12 VDC
Resultant Camera Voltage	21 VAC	21 VAC	11.5 VAC
100 mA B&W Camera
Dual 24 AWG	1,000ft	2,500ft	175ft
Dual 22 AWG	1,500ft	4,000ft	300ft
300 mA Color Camera
Dual 24 AWG	350ft	850ft	50ft
Dual 22 AWG	600ft	1,400ft	100ft
1 Amp P/T/Z Camera
Dual 24 AWG	100ft	250ft	15ft
Dual 22 AWG	150ft	400ft	300ft

Notes: wire can be category 2 or better. low-voltage camera power, video, and RS-422 or RS-485 may be sent within the same wire bundle. Do not run 24 VAC or 28 VAC in the same wire bundle with other telecom or datacom signals.

Environmental

Temperature

-20 to +75 C

Humidity (non-condensing)

0 to 95%

Mechanical

Dimensions, including connectors

19" wide, 1.73" high, .8" deep (482mm wide, 44mm high, 21mm deep)

Weight

0.94lb (0.43kg)

Mounting

Rack Mount

* Specifications subject to change without notice.